[NTLK] [OT] NewtCOM and its case 3D printing design

[Doug]

Matthias,

How did you model the NetwCOM for 3D printing? Did you start with someone
else's 3D model? Did you approximate the different shapes you saw stacked
on top each other and just kept adding and approximating until it was close
enough?

When you made the cases for them, did you use the exterior of the NewtCOM
then go +0.1mm proud of each surface to define the space it would fit into
in its case?

I'm asking because I have two complicated, mating surfaces that need to be
3D modeled so they match complimentarily and since you seem to have done
that already, maybe I can learn something from how you did yours.

Doug